25mm~75mm 1 Inch~3 Inch Button Parts for Badge & Button Making Machine DAWEI 1001 Parts Supply 100 Sets (φ56mm 2-1/5 Inch)

These are crap. Quality control is crap. I'm at a 30% failure rate and climbing. Also, some buttons have black speckling. Never ordering these again.Update - 20 defective buttons out of the 66 made so far. I'd return these, but I don't have the time right now.

I ordered these for a convention and for a button press that I had ordered that was 2 inches. First order seemed fine but the second ended up a different size even though I ordered the same product again. And of course by the time I needed them for the convention, the return date had passed. I tried using them, even the coreect size ones, and they wouldnt even clamp down. They would just fall apart. I would not recommend at all.

The size is slightly bigger which is a huge negative. It has to be forced into its place and is so tight that the paper rips each time. The mylar circles are too big to fit into their place.I would not buy these again. They were a waste of money. I got them from here because I needed them quick. I got them quick but I wish I didn't get them at all.

These DO NOT work in the Tecre 1" machine. The quality of the pieces is fine, and I like the design of the backs. So if they do fit your machine, you are good to go. But they don't fit the Tecre. The disk and the mylar are slightly bigger, so the shrink wrap effect doesn't work. I tried other mylar, but the disc is too wide. The edge lifts and the buttons are duds.

This item was pure garbage. First we had to put the pins into the backs, which was time consuming. Once pressed with the pin maker, the back would crack.. So much worse than the pins that came backs assembled with the pin press. The better buy is the button press along with 1000 buttons, Back comes assembled! for $40 more from Banyon. 500 pins-wasted!! $60.00 wasted. DO NOT PURCHASE THIS ITEMI gave it a one star because I couldn’t go any lower.

Literally half the buttons came out messed up and unusable. The other half im worried will mess up after its sold. Im a little scared to sell them.would NOT suggest at ALL

Shells were far too thin, the backing was just a bit too small compared to the shell, and the mylars were too big to even fit into the machine properly.Not a single button came out looking the way it ought to have.

good product