10FT Cable Blanket Low Profile Cord Cover and Protector, Black

I’m a teacher in a classroom where I wanted a layout that meant I needed to be able to safely walk over a power strip cord, AV cable, and two Ethernet cables. Not many cable protectors can hold that much, and if they do they are REALLY bulky. I’m a klutz, and I knew if I had a speedbump like that to go over I would be tripping CONSTANTLY.I was delighted to find this, although (remember: teacher!) I was put off by the price, since you can’t really reuse this year to year (we have to clear out rooms so they can do deep cleaning each summer) because it is adhesive.So to save money I decided that 2.5 feet would be just enough (you can see I could have used another 6 inches or so in my pic above!) so I cut the roll in half.I’ve now used that roll up over the past 2 years, and I ordered the double pack which will last me 4 more...this thing is great!The adhesive was surprisingly durable, despite frequent traffic, and occasional roll-overs with my desk chair. It didn’t damage the short, institutional school carpet either time, and it let me really squish down those cables really, really flat.This is a great product!!

It blends in with my deck and hides the cable. The attached sticky product did not work and I had to apply a different double side tape.

i like the gray color, i also was happy i finally found something wide enough to fit my cable wires that are on my floor, i have wood floor tiles and the cord cover stuck nicely to the my floor. i would say its a good buy although i didn't care for a very small portion of the sticky part didn't work so now a little piece is not sticking to my floor and sticking up instead.. other than that its a great product and very easy to install

This cord cover is low profile and able to accommodate several wires underneath. But the two-sided tape that comes with the cover is weak and doesn't hold well on floor surfaces. There is a fix -- applying stronger two-sided tape. That's what I did, and it now holds fine. My advice is that if you want this cover to remain stuck to the floor surface, buy a roll of strong two-sided tape to replace the adhesive tape that comes with this cover.

Attractive and practical. Protects several cords/cables with ease. Very easy to trim, and the peel-and-stick adhesive strips hold extremely well without leaving any residue on the floor. Super product!

I was an unwitting middle man between the seller and landfill. There are several things wrong with this product. 1) There is barely room for two cables. I have a 220v and 115v cable that need to be covered. However, the profile of these two cables barely fit in the cavity designed for the cables. 2) The tape backing on the adhesive was inconsistently covering the adhesive. Looks like it was displaced when the cover was rolled up before being boxed. 3) The adhesive was inadequate to the task. I cleaned the surface of dust and debris before trying to lay down the cover, but the adhesive did not adhere to the material of the floor. The floor in my shop is similar to brick in composition but seamless as it must have been poured and then smoothed out. Probably not the best material to glue to, but it did not stick at all. Anyway, don’t buy if you have multiple cables of above average size or a bare concrete or brick-like floor.

Had to replace a wire cover that was to high for my Robot vacuum to get over. This worked perfectly. Covers about six cords two of which are thick. Adhesive working for now. If needed I'll add double back tape. Robot cruzes over this strip cover.

It's a good size for multiple cords or wires, 3 to 4 depending on the thickness, but the adhesive is terrible. After just 1 day of being applied to the floor it has begun peeling off at the ends.